Heater Vents

 This was going to be a bigger job than I thought .From a previous blog i have decided to fit Bluetooth speakers for use when the engine is off !!! .this has made a tight space even more tight .

The first issue was that there didn't seem to be enough room for the pipe coming from the screen vent to turn with out kinking or sitting on the tray which i didn't want  .

Second issue was that I wanted most of the heat to be in the footwells so had to devise some way to do this 

Third issue is i have a aux socket on the passenger side so want to put fuses on the undertray for the reverse lock out the Bluetooth and the aux socket.   

After brainstorming with Steve and buying a selection of fittings we (Steve !) came up with a plan . we found out by chance that the solvent plastic fitting are smaller than the push fit ,

First we cut the screen heater pipe as short as we dare .

heater screen cut down 

and then a male /female bend just went in with a bit of persuasion  .

 self tapping screw to hold in place 

next was the floor vent again using solven fittings 45 deg this time it gave us a sweeping bend 

the final challenge was to try and get as much air to the floor, idea was a equal tee on the pipe with the straight though going to the floor ,so if screen was required I can shut the floor vent .( if it works )   

finished  and repeated for drivers side 

 

Think this has gone in really well considering the room we didn't have .