Last couple of jobs before i can go for a power up is the Ignition switch and the steering stalks ,
The ignition switch is the Lucas type ,It threw me at first as i expected the switch to be
OFF-AUX-IGN-Start however it isn't mine is AUX -OFF-IGN- Start
there is no wiring diagram in the box and nothing i could find in the web about wiring so after a bit of time arrived at
Contact 1 also being at the top ,
I looked at the cables in the loom and they are 6mm so figured should use the same ,with the GDkit comes the spades and the housing for the plug so that was easy and soldered them for piece of mind however on the switch end that was another issue should have used yellow crimps due to the size of the cable but, as i was presented with double connections came up with another idea
first i split the cable into 2 then put the insulation back on , I could then use 2 blue terminals on both of the connections
 |
| insulation slides back on (note the heat shrink) |
 |
| crimped up |
Once crimped i the put heat shrink on the join , repeated this for the AUX and IGN
 |
| heat shrink applied |
 |
| Completed |
No comments:
Post a Comment