Again before the final fit of the fuel tank wanted to secure the boot wiring ,this has to be done with clips no more than 300mm apart .we used p clips and self tapping screw to secure the wire .
The fuel pump wire was the starting point as that goes though a hole between the 2 fuel pipes, i used a 20mm plastic fitting to grip the wire ,my idea was to leave the fuel wires as long as possible so i could fit the fuel pump wires to the pump before fitting it back ( not a lot of room ) and be able to take it down if needed
 |
| fuel pump wires threaded though |
initially i planed to route the cable round the outside edge of the boot but the self tapping screws would be seen , so opted for straight across and protected the wire with so 15mm foam .
amongst the wires are cables for heated screen and boot light which i don't intend to use so will tuck those in the gap at the side of the fuel tank ,apart from the obvious cables that feed the lights there was also a another connection which is the number plate light I plan to take that up the side of the car to the boot hinge ..
No comments:
Post a Comment