Dash board part 7

 Been to GD and got a replacement Start button and at the same time got advised that the button will not carry the intended start current !!! 

So Relay now required , fitted the relay on one of the gauges ,as per a previous post i intend to use the engine start light as an oil pressure light so this means that i will need to supply a feed to the light an then the iol pressure sensor will evevitivaly earth it putting the start light on when there is no oil pressure ie engine stopped .

Relay can be seen attached to fuel gauge with the feed coming from the volt gauge  

The gauge lights i have fitted using male spades for the positive but the negative i fastened to the gauge nus to try and increase the earth paths  

Left the speedo and tacho Gauges out to make it easier to fit the dash (hopfully )