Mirrors

 Next job was to look at fastening the mirrors .

From the CD the 5mm threads need to be on the ceter line and bottom one 10mm down from the second windscreen hole and the second 38mm up from that .

Expected it to be hard drilling but it went surprising easy ,drilled 4mm and tapped to 5mm (should have need 4.2mm but only had 4mm drill) 

removed the mirror from the box and quickly discovered all i wanted was the shell and the glass ,removed the glass and the securing bolt and fitted to my pillar.

fitted and checked that the bolts do not show through 

Left the glass out for now as they have to come off to fit the windscreen .

Leather

 First piece of leather to fit is the transmission tunnel top cover ,was dreading this so needed moral support in the way of Steve .

Marked the top of the gear stump with grease and placed the leather on top to give us a clue .

then cut a small hole just big enough for the shaft .

Cutting out the small hole 

It would then lay on the transmission tunnel in the right place ,between us we came up with the idea of replacing the bolts with sharpened studs which will mark the fiberglass backer 

sharpened studs 

this worked very well and gave us the position of the three holes  then using the ring we could calculate the diameter and position of the gearstick hole .

This was drilled out with a hole saw and then the leather was cut with a knife .

The gater was eased into position and stretched until it fitted in the ring and then screwed down.

sure, he hates me 

the finished effect looks brill thanks Steve 

the back of the leather lifts up but that should be trapped by the back piece and if not going to glue some velcro tape to the back which will stick it to the carpet .

Steering wheel

 Got the steering wheel out of the box and surprise its doesn't fit, quick call to Andy and he tells me that the splines on the housing need to be filed a bit or i can just force it on .

Didnt like the idea of forcing anything as knowing my luck i would need it off, using needle files set to and filed each spline until it fits, assembled the steering wheel 

idea was that the Column can be moved back and forth until it is fixed in place so wanted to make sure the driving position was correct.

Wheel in the correct position 

Now i know where the column wants to be i can sort out the cover and fit the dash .