Fuel Bleeding and leak checking

 After looking at Dales blog realized  that bleeding the fuel and also flushing the pipes was a sensible idea  so made a fused wire to go from the battery to the fuel pump and released the pipe from the engine ( avoid using the bleed screw on the fuel rail as any dirt may affect the seal  started the fuel pump to bleed the system .

I was amazed at just how much fuel coms out the pipe the pump was only running for a short time and my container was full .

Re attached the pipe and pleased to say no leaks . 

Door carpet and Door

 After the Bathroom replace its back on the car !

In order to fit the door properly figured the carpet will need to be in as this might alter the fit of the door 

fitting the door carpet is quite straightforward with a bit of pulling and stretching to make the carpet sit right with the rubber ..

door carpet fitted 

Could only fit partially as needed to adjust the hinges so a bit of a mess about but happy

moving on to the door card and it comes pre drilled with the hole for the handle  

hole cut were the cardboard was pre cut 

when trying to fit the door card to the door the hole seemed to be in the wrong place and would make the door card sit wrong when the door is shut .

solution was to move the door handle to fit the card .

door handle fitted on the bracket also drilled/ tapped the sliding bracket to stop it moving 
 

door handle moved to fit the door card ,

now it fits the card and the card follows the contour of the door .the door card sits on the door with the normal push fit door fasteners so fitted those and then mad a cardboard template so i can tranfer this to the door .

card template 

door masked out ready to be marked