Fuel pipes and Wiring

 After refitting the fuel pump after wiring it up was able to fit the pipes on to the tank fittings 

fuel pipes fitted 

The strainer does not have any arrows on it but on one of my camera happy visits to GD i have taken a picture of this and that's' the way Andy fitted it so works for me ,happy with the gland to fit the cable as allows me to "lose" the spare cable in the boot but should I need to take it all down there will be enough slack cable.

Reversing light 

Been putting off fitting the reversing light for some time as marked  it out while the body was on the stand and just wasnt happy that it looked right ,due to the shape of the car so difficult to get datum marks .

Once the boot was on and fitted using the handle gave me another reference so at least it would look right .

measured from each side on the boot handle and each side of the lights and eventually was happy so fitted finally .

Again using the stand offs supplied by Andy I have opted for the lights to have the screws up and down so using the stand off i could use the existing screws just had to extend then with 5mm barrel nuts .

finally happy  looks good 

flushed with success decided to finish the wiring in the boot . The loom naturally goes to the 2 sides of the car and everything is duplicated .My wiring loom had 2 earths each side instead of the 1 shown on the diagram .checked with a meter and they were both good ,so used the Bullet joinerfor 1 earth and brake/tail + indicator and a straight joiner for the other earth and reversing light or fog light .

once the wires were all conected set out to try and tidy it up a bit ,using a p clip to the indicator fixing made it look a lot better ( get covered with carpet anyway .

wiring with p clip and tie wraps