Heater

Thought I would tackle the heater fitting as my first job  .After reading Dale's blog realised that the "wings" need to be cut off .angle grinder made short work of those .
Problem then is nothing to fasten the heater with .
Again Dale's blog sourced the answer 4 6mm Rivnuts . Note heater internals need to be removed before drilling to stop the drill going into the matrix




Heater shown with the wings off and the 4 rivnuts 

Heater fitted but then realised that there was no space for the pipes to connect up so first mistake
refitted after elongating the heater outlet holes and drilling new securing holes
good job its covered by the dash

heater from the passenger side showing the extent of my error