Fitted the radiator but didn't have the fixing kit (2 bits of pipe!) so used 16mm grommets which seemed to work so I could figure out haw the pipe work went.
Again Dales blog to the rescue
And I realised that the header tank needs rivnuting to the cross member ,used 8mm rivnuts and made sure the pipe was in line from the engine .
 |
| Header tank fitted with pipes still loose |
Then it was just a simple task to fit the other side again only loose as it will all have to come off when I collect the heater pipes .
 |
| Pipe fitted but will need trimming level |
No comments:
Post a Comment