Light wiring

Next task was to start with the wiring started at the drivers side and worked my way round .
Using the GD diagram the wires.  are quite straightforward .
Knowing how much water plays havoc with wiring wanted to make sure in the unlikely event of being caught out in the wet at least the wiring would stay dry .
Placed heat shrink on the headlight  cable so that no water could get in the cables and used the bullet connectors supplied to connect up followed by adhesive tape to seal it all in .
At this point I was not happy with how exposed the indicators were so decided to try and protect them a bit .
After some thought cam up with half a tennis ball  ! I extended the light securing screws with 5mm barrel nuts (tool station ) and then fastened the tennis ball with 2 more 5mm nuts after painting think it look better only time will tell .

Still wet should blend it when dry !

As in the same picture fitted the mesh covers at the same time these were fabricated  by Steve whilst laughing at my tennis ball idea ,he  had to make a wooden template to form the mesh round as the hols were already cut so couldn't use the piece cut out and have to say fitted first time .